kiteboatproject

K2 Test – Aug 22

8/22/12

A late evening test today. We used the new carbon winch, but added a 5th-line spool (to the left of the orange stripe in photo) instead of trying to use the fishing winch for the 5th line. We also added a carbon hood for the winch, and we moved the brake to the outside and back of the chair. We replaced the new single-pole mast with the old A-frame, in order to ensure that we could launch and test the winch. With fewer new changes, we were able to get the kite up fairly easily and to sail around a bit before dusk fell.

Kite Inflator Specification

8/20/12

Kite Inflator Specification

[This document is a work in progress.]

The kite inflator is a device that monitors and sets the inflation pressure of the kite. It will also serve as a general purpose data logger and transmitter for sensors such as an altimeter, temperature sensor, and GPS.

Physical, Environmental, Performance

1. max size: ?
2. max weight: ?
3. kite attachment method: ?
4. splashproof, but not submersible
5. external power switch and on/off display
6. normal use constitutes the motor valve operating for 25% of the time
7. must run for 12 hours of normal use on a full charge
8. reliable radio range of 100m on the water
9. […more]

K2 Test – Jul 27

7/27/12

We had another great K2 test today with the 40 sqm v10 kite. Today was the first day we used the new fishing pole mast, one idea for simplifying the kite launch and reducing drag while sailing. This mast consists of just one long carbon pole instead of two, and can be disassembled after launch very quickly. We successfully launched the kite after only two tries using this mast and were able to break it down in less than a minute. Although it worked well on the second try, there was a lot of flex, which contributed to launching difficulties on the first try, and which probably means that any long-term version of this mast would need to be made […more]

K2 Test – Jul 20 – Bridge crossings!

7/20/12

Today’s test was epic. We covered the distance from Alameda to the Golden Gate Bridge and sailed all around the waterfront near Hunter’s Point and Crissy Field. We crossed under the Bay Bridge on the city side for the first time, and under the Golden Gate Bridge and back twice each. We witnessed the tail end of a kitesurfing race by St. Francis Yacht Club, and got some great photos. In an over four-hour test, the boat worked very reliably, and we hit a top speed of 29 knots with three crew members and the 40 sqm v10 kite.

K2 Tow Test & Kite Test – Jul 18

7/19/12

We took K2 out this evening for a tow test. We towed the boat in circles in the protected area by the big ships, and stopped every so often to adjust the foils and tow again. We are playing with different pivot point locations. After towing, we also briefly tried the boat with a kite, making a few more adjustments. The wind was very light, so we did not foil while using the kite.

K2 Test – Jul 12

7/12/12

Another long K2 test today, this time with the 30 sqm kite, and gaskets on the bottom of the foil sockets to reduce drag. The gaskets definitely kept spray from passing through the hulls, but the expected drag reduction at lower speeds was small enough that it was hard to quantify, particularly in the choppy conditions.

Kai View Data:
20120712-k2.kai.bz2