The wind was strong today, and the bay was a bit rough, so we opted for the 18 sqm kite to test our new hydraulic steering system. The steering wheel worked well–the feel was better than expected, and the placement of the wheel allowed Don and Joe to communicate more easily, although Joe’s new position was significantly wetter than his old position. The next step will be to move the ride height adjustment buttons from the tiller to somewhere on or near the wheel.
We were joined on this test by visiting kite designer Germain Belz. Today was also Andrew’s first time driving the Protector for us, and he did a good job of positioning the chase boat for photos.
We’ve been curious about the distribution of rear line loads, and have recently been collecting load data from both lines. The result is a bit of a surprise. As expected, the “top” rear line has a higher load, but the difference between the top and bottom lines is smaller than anticipated: typically only a few kgf, out of a total rear line load of up to 120 kgf.
The top attached histogram shows the distribution of the total rear line loads. The second histogram shows the difference between the right and left lines when on a starboard tack, and the third histogram shows the same for port tack. This data comprises the entire test on March 5 during which the […more]
We took K2 out today in blustery conditions with winds from the South. We flew the same 50 sqm kite as yesterday, with this morning’s new bridle. The bridle distributed the load in such a way that the kite looked very flat, and we decided both that this bridle was not an improvement and that it was too windy for such a large kite. We then launched the 18 sqm kite with the unusual planform, which we had not yet flown in sufficient wind. The 18 sqm kite performed very well, and we hit a top speed of 33 knots with 3 crew. Attached kite closeups are mostly of this kite. We will try […more]
First test with new 50 sqm kite. Unimpressive performance. Will change the bridle and try again tomorrow. Mary Baker, Betsy’s mom, joined us on this test.
Today we tested again with the red K1 rudder. Consensus: red K1 rudder is much inferior to K2 rudder. We also tried several new camera angles from the Protector, including driving under the kite lines for the first time. Jacques Vincent joined us on this test.
A short test today with the red rudder from K1. We also tried some new camera angles from the Protector, including driving directly in front of and directly behind the kiteboat. Jacques Vincent joined us on this test.
Today we took K2 out for a tow test with one of the two K1 rudders (white rudder) that we modified for use on K2. We towed in a straight line while slowly accelerating to 22 knots, then stopping and slowly accelerating again. We attached the tow rope to the chair so we could record load data for this exercise. We then launched the kite near Treasure Island and kited briefly with Michael Specter from the New Yorker, who joined us again. The wind was very low, and we had trouble keeping the kite aloft, but we were able to both launch and sail in about 6 knots of wind. We also saw some more of the Youth America’s Cup […more]
