Another test of the new T-foil, with good performance. Ride height adjustment buttons are now separate from the tiller, and currently located next to the steering wheel on the mast. Don hopped on the Protector briefly, and Joe and Greg kited alone for one starboard tack, hitting a top speed of 28 knots. Germain Belz joined us on this test.
Today we tested K2 off Alameda using the 18 sqm kite. We have been using the old A-frame launch mast on the front of the Protector for kite tests, and we left it up today as a camera mount, to take semi-aerial photos of the kiteboat. We also used a backpack-supported ski pole mount of our own design to take GoPro video on the boat. At the end of the day, we sailed all the way back to dock.
The wind was strong today, and the bay was a bit rough, so we opted for the 18 sqm kite to test our new hydraulic steering system. The steering wheel worked well–the feel was better than expected, and the placement of the wheel allowed Don and Joe to communicate more easily, although Joe’s new position was significantly wetter than his old position. The next step will be to move the ride height adjustment buttons from the tiller to somewhere on or near the wheel.
We were joined on this test by visiting kite designer Germain Belz. Today was also Andrew’s first time driving the Protector for us, and he did a good job of positioning the chase boat for photos.
We’ve been curious about the distribution of rear line loads, and have recently been collecting load data from both lines. The result is a bit of a surprise. As expected, the “top” rear line has a higher load, but the difference between the top and bottom lines is smaller than anticipated: typically only a few kgf, out of a total rear line load of up to 120 kgf.
The top attached histogram shows the distribution of the total rear line loads. The second histogram shows the difference between the right and left lines when on a starboard tack, and the third histogram shows the same for port tack. This data comprises the entire test on March 5 during which the […more]
We took K2 out today in blustery conditions with winds from the South. We flew the same 50 sqm kite as yesterday, with this morning’s new bridle. The bridle distributed the load in such a way that the kite looked very flat, and we decided both that this bridle was not an improvement and that it was too windy for such a large kite. We then launched the 18 sqm kite with the unusual planform, which we had not yet flown in sufficient wind. The 18 sqm kite performed very well, and we hit a top speed of 33 knots with 3 crew. Attached kite closeups are mostly of this kite. We will try […more]
First test with new 50 sqm kite. Unimpressive performance. Will change the bridle and try again tomorrow. Mary Baker, Betsy’s mom, joined us on this test.
Today we tested again with the red K1 rudder. Consensus: red K1 rudder is much inferior to K2 rudder. We also tried several new camera angles from the Protector, including driving under the kite lines for the first time. Jacques Vincent joined us on this test.
