hulls

Sensor placement

2/22/12

Gabe and Damon used the laser level to sight the sensor placement and then Damon drilled holes in the side hulls where the sensors should attach. Gabe and Joe just laminated reinforcements on those holes and Joe showed off the sensor bearings, which will fit in those holes.

Sunday update

2/19/12

Today we worked on:

1. The fillets and taping around the beam to the hull intersection at the outer skin.

2. The foam wedges between the bulkhead assembly and the ama decks.

3. The backfill Nomex edges on the bulkhead assemblies.

4. Additional operations on the lower foil cassette panel.

Saturday work party

2/18/12

Gabe and Joe showed up to get a few things done.

1. The foil cassette panel, which supports the point-loading of the lower rollers using a core, which is a combination of airex foam and 1.5mm thick webs of carbon spaced 12mm apart.

2. Sea anchor deploy tunnel, which connects to and also drains the dry well storage area.

3. Secondary filleting and taping of the inboard ama hull halves.

K4 bulkhead update

2/10/12

Damon is working on permanent installation of the bulkheads. He also attached the rudder supports for the center hull.